|Availability:||Out of stock|
Please order from our new eCom site at: www.shopraddcruisers.ca
These are the direct replacement fit 11mm ARP Head Studs. Kit comes with 26 studs and hardware.
These ARP head studs provide clamping forces that are 40% greater than the stock torque to yield bolts.
No modification to head bolt holes in the block or head is required. This will help gain the increased head clamping required in performance applications. They will achieve a more evenly distributed and accurate torque load compared to that of head bolts by eliminating the twisting force created during tightening. This ultimately translates into higher reliability and a lower chance of head gasket failure.
Testing has demonstrated that stock TTY head bolts range around 11,000 lbs of force on average, these ARP studs provide considerably more even clamping forces averaging 15,785 lbs.
Installation instructions are included in the kit.
• Do not use the factory torque procedure with this head stud kit.
There is a 13mm version available for even greater clamping force, however these require machining the block (drilling and tapping) and drilling the holes in the head for clearance. Please enquire if you are seeking this particular head stud kit (13mm Kit = HSKTO360).
Note: Make sure the head bolt holes are properly cleaned out, and that you use the supplied ARP Ultra Torque lubricant under the nut and washer while torquing in to place.
replaces head bolts:
90910-02096 No. 1 bolts x6 pcs
90910-02119 No.2 bolts x20 pcs
ARP - Made in USA
Please purchase insurance with your order!
RADD Cruisers is NOT responsible for any item after it leaves our custody.
When this item is out of stock, I will accept Pre-Orders with full payment. Items will be shipped on a first-ordered, first-shipped basis. Limited stock has already been reserved from the supplier.